Dronius Pryvyd 20x FPV Drone Racing Frame
| BUY FRAME |
Racing frame for 20x20mm stacks and nano cameras. The frame is designed and tested in training and competition throughout the second half of 2021. All top places on the podium of the 2021 Ukrainian Drone Racing Championship were taken with Dronius racing frames.
The Pryvyd 20x combines ease of assembly with high strength and structural rigidity.
Frame set included
Carbon pack
- 1x Bottom Plate 2mm
- 1x Wiggle Plate 2mm
- 1x Middle Plate 2mm
- 1x Top Plate 2mm
- 1x Addition Camera Protector 2mm
- 4x Arms 5mm
Hardware Pack
- 8x Press Nuts
- 4x Titanium Flat Head Screw M3*25 (for wiggle plate and stack)
- 4+1x Steel Button Head Screw M3*12 (for securing standoffs & arms)
- 4+1x Steel Flat Head Screw M3*10 (for securing arms)
- 2+1x Titanium Button Head Screw M3*8 (for securing top plate)
- 2+1x Titanium Button Head Screw M3*6 (for securing top plate)
- 4x Aluminium Standoff M3*25
- 1x 3M rubber anti-slip battery pad
Titanium 25mm bolts hold the middle wiggle plate and allow mounting up to 3 "floors" of 20x20mm control boards.
Strong arms fixation with a unique wiggle plate.
5mm thick arm carbon + 2mm middle plate under standoff add structural strength to the front and rear.
Using strap for a battery up to 20 mm wide. The gap between the bottom and middle plate is 3mm wide, allowing you to use almost any type of straps without having to remove the bottom plate.
The arms are made of carbon fiber 5 mm thick and have a width of up to 9 mm. Additional technological thickenings are made in places of the highest stress. Three holes for mounting motors with a configuration of 16x16 mm.
Frame weight with 4x25mm bolts for stack and without TPU - 69 grams
Dronius Pryvyd 20x for FPV Racers from Ukraine!
| BUY FRAME |